1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Back to a flathead.. Motor mount question

Discussion in 'Flat Fender Tech' started by junkfood, Apr 25, 2007.

  1. Apr 25, 2007
    junkfood

    junkfood Member

    Casa Grande,Az.
    Joined:
    Oct 23, 2005
    Messages:
    222
    Well I am looking at taking my 2a back to a flathead. The frame has been modified to mount a V6 and the flathead mounts are gone.. Question is, where can I get frame mounts for the flathead motor?
    Thanks
    Keith
     
    junkfood, Apr 25, 2007
    #1
  2. Apr 25, 2007
    w3srl

    w3srl All-around swell dude Staff Member

    Port Orange, FL
    Joined:
    Nov 6, 2002
    Messages:
    4,275
    Your best bet would be from a donor frame IMHO. The frames don't normally rust around the mounts, so even a roached out frame could be a good donor. You'll need a couple of sharp drill bits (3/8" and one smaller for a pilot hole) to drill out the rivets and also a handheld grinder to grind off the tack-welds.
     
    w3srl, Apr 25, 2007
    #2
New Posts