1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Floor board in the way

Discussion in 'Early CJ5 and CJ6 Tech' started by nrg0920, Mar 16, 2007.

  1. Mar 16, 2007
    nrg0920

    nrg0920 New Member

    Raleigh, NC
    Joined:
    Feb 1, 2007
    Messages:
    38
    I was installing the Warn overdrive tonight, and found that it hits the bottom of the floor pan on the Jeep; has anyone ran into this problem? I do not want to install a body lift, I was thinking about cutting a hole in the floorboard between the seats and installing a raised box….any suggestions would be great.
     
    nrg0920, Mar 16, 2007
    #1
  2. Mar 17, 2007
    Gixx

    Gixx Member

    Albuquerque, NM
    Joined:
    Mar 28, 2005
    Messages:
    111
    Hmmm, mine has penty of clearance. Have you checked your motor mounts ? MAYBE if the engine has dropped down, then the tail of the transmission/transfer is sitting up higher than usual ? Other than that, a raised box in the floor should be reasonably easy to fabricated.
     
    Gixx, Mar 17, 2007
    #2
  3. Mar 17, 2007
    jpflat2a

    jpflat2a what's that noise?

    Hermosa, SD
    Joined:
    Jul 30, 2003
    Messages:
    8,524
    if the mounts check out okay
    spacers between the crossmember and frame ?
     
    jpflat2a, Mar 17, 2007
    #3
New Posts