1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

D27 spindle bushing ID spec.

Discussion in 'Early CJ5 and CJ6 Tech' started by Toolmaker, Dec 3, 2006.

  1. Dec 3, 2006
    Toolmaker

    Toolmaker Member

    Westminster, SC
    Joined:
    Oct 3, 2005
    Messages:
    132
    Does somebody know what the ID specs are for Dana 27 spindle bushings? I ordered new bushings from Krage and they are .012 to .013 bigger on the inside than the old bushings.

    Thanks in advance!
     
    Toolmaker, Dec 3, 2006
    #1
  2. Dec 4, 2006
    jeepdaddy2000

    jeepdaddy2000 Active Member

    Eagle Point oregon
    Joined:
    Jun 24, 2004
    Messages:
    1,193
    is that measurement after installation?
     
    jeepdaddy2000, Dec 4, 2006
    #2
  3. Dec 4, 2006
    Toolmaker

    Toolmaker Member

    Westminster, SC
    Joined:
    Oct 3, 2005
    Messages:
    132
    The old bushings are still in the spindles right now. I can't see the ID of the new bushings shrinking by .012. I know they will draw up some due to the press fit, but not that much. The old bushings may be OK, that's why I want to know what the FSM calls for on the ID before I remove them.
     
    Toolmaker, Dec 4, 2006
    #3
New Posts