1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

caster shim pictures.

Discussion in 'Builds and Fabricators Forum' started by zed, Nov 13, 2005.

  1. Nov 13, 2005
    zed

    zed Iowa- Gateway to Nebraska

    central iowa
    Joined:
    Aug 4, 2004
    Messages:
    745
    mike here are the picts i was talking about.
     
    Last edited: Aug 11, 2008
    zed, Nov 13, 2005
    #1
  2. Nov 13, 2005
    ljspop

    ljspop Lurking Bronco Dude

    San Diego, CA
    Joined:
    Jan 29, 2003
    Messages:
    394
    Hey Zed - those aluminum ones are trash they'll break pretty quick - but you probably know that or you wouldn't be posting. You can cut down the Ranchos to the proper width if they are the correct angle.
     
    ljspop, Nov 13, 2005
    #2
  3. Nov 13, 2005
    Mcruff

    Mcruff Earlycj5 Machinist

    Albertville, AL
    Joined:
    Sep 22, 2002
    Messages:
    5,349
    If you want a set of them I will go ahead and make a set of 3ยบ ones for you. I made a set for Bobs flattie also awhile back.
     
    Mcruff, Nov 13, 2005
    #3
  4. Nov 13, 2005
    zed

    zed Iowa- Gateway to Nebraska

    central iowa
    Joined:
    Aug 4, 2004
    Messages:
    745
    thanks all.

    bob the rancho's for the rear measure about 2* or 2.5* BUT they are aluminum also. that's why i figured i'd ask mike about the steel ones he makes.

    ,
     
    zed, Nov 13, 2005
    #4
  5. Nov 15, 2005
    lynn

    lynn Time machine / Early CJ5 HR Rep Staff Member

    Huntingdon PA
    Joined:
    Sep 20, 2002
    Messages:
    3,437
    Go with steel.
    I have to run 5-degree steel shims up front due to my D30 swap...
     
    lynn, Nov 15, 2005
    #5
  6. Nov 15, 2005
    zed

    zed Iowa- Gateway to Nebraska

    central iowa
    Joined:
    Aug 4, 2004
    Messages:
    745
    thanks lynn
     
    zed, Nov 15, 2005
    #6
New Posts