1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Hydraulic clutch

Discussion in 'Builds and Fabricators Forum' started by Deputy Dave, Sep 23, 2005.

  1. Sep 23, 2005
    Deputy Dave

    Deputy Dave New Member

    washinton ut
    Joined:
    Apr 6, 2005
    Messages:
    19
    just wondering if antone here has put a hydraulic clutch set up on a 225 bellhousing and a t-90 trans i have a few i deas that i think will work but just want to see any other options
     
    Deputy Dave, Sep 23, 2005
    #1
  2. Sep 23, 2005
    Jeepenstein

    Jeepenstein Me like Jeep.. 2024 Sponsor

    North Central FL
    Joined:
    Jun 15, 2003
    Messages:
    2,159
    Jeepenstein, Sep 23, 2005
    #2
  3. Sep 23, 2005
    DanStew

    DanStew Preowned Merkin salesman Staff Member

    Lexington, South...
    Joined:
    Sep 22, 2002
    Messages:
    4,586
    I made a bracket for a pull slave cylinder, it bolted to the bellhousing to tranny bolt and went al lthe way back t bolt onto one of the Tcase bolts.
     
    DanStew, Sep 23, 2005
    #3
  4. Sep 23, 2005
    bigbirdcj

    bigbirdcj Member

    Keedysville,...
    Joined:
    Feb 22, 2005
    Messages:
    61
    I mounted 80's CJ parts on mine. There is a small bolt hole in the bellhousing you have to drill out and tap and then drill and tap a second hole. I had to weld an extension onto my clutch fork. but you could probably find a longer fork that would work. One of the best mods I've done.
     
    bigbirdcj, Sep 23, 2005
    #4
  5. Sep 23, 2005
    Hansh

    Hansh Going Mobile

    SE Wisconsin
    Joined:
    Dec 7, 2004
    Messages:
    425
    I bought my kit from Novak. Bolts to the side of the bellhousing. I used a Master Cylinder from a Wrangler.
     
    Hansh, Sep 23, 2005
    #5
  6. Sep 23, 2005
    wheelie

    wheelie beeg dummy 2024 Sponsor 2023 Sponsor

    York, PA
    Joined:
    Mar 6, 2004
    Messages:
    4,521
    Used a puller type slave. Drilled and tapped into one of the "ears" on the side of the T14A housing and bolted the end of the slave there.
     
    wheelie, Sep 23, 2005
    #6
  7. Sep 24, 2005
    Posimoto

    Posimoto Hopeless JEEP Addict

    Minden, Nevada
    Joined:
    Aug 7, 2003
    Messages:
    4,539
    Here's my slave setup. Its a Wilwood pull back type. Since this pic was taken, I've added another plate off theback of the T Case to stiffen up this bracket.
     
    Posimoto, Sep 24, 2005
    #7
  8. Sep 25, 2005
    Deputy Dave

    Deputy Dave New Member

    washinton ut
    Joined:
    Apr 6, 2005
    Messages:
    19
    hey hansh wich kit did you get from novak?? i looked on the site and saw one but it doesnt work for the 225 bellhousing
     
    Deputy Dave, Sep 25, 2005
    #8
New Posts