1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

t-98 to 134 adapter

Discussion in 'Early CJ5 and CJ6 Tech' started by CJMace, Jun 1, 2005.

  1. Jun 1, 2005
    CJMace

    CJMace Member

    Columbus, OH
    Joined:
    Feb 20, 2003
    Messages:
    60
    Does anyone know of or have one of these elusive adapters that they are wanting to sell?? I have been looking for a while, without luck. If anyone knows of any, even with an old CJ attached, I would be interested. This burning itch for low gears is getting painful. Thanks in advance
     
    CJMace, Jun 1, 2005
    #1
  2. Jun 2, 2005
    BobS

    BobS New Member

    Pelican Rapids, MN
    Joined:
    Dec 14, 2002
    Messages:
    6
    Do you already have the T-98 and the T-case adapter? It wouldn't be that hard to make the front adapter.
     
    BobS, Jun 2, 2005
    #2
  3. Jun 3, 2005
    DanStew

    DanStew Preowned Merkin salesman Staff Member

    Lexington, South...
    Joined:
    Sep 22, 2002
    Messages:
    4,585
    i had the front adapter, and it wouldnt be hard to make. it was just a piece of cast steel about an inch thick. the only other thing differnt was the bearing retainer, now that would be a hard piece to find for th et98, but most likely you can one modified to work. for the rear adapter it is the same as the dana 20 adapter used in the later t18 jeep vehicles, or you can even get the novak adapter, it is based off th efactory adapter
     
    DanStew, Jun 3, 2005
    #3
  4. Jun 3, 2005
    BobS

    BobS New Member

    Pelican Rapids, MN
    Joined:
    Dec 14, 2002
    Messages:
    6
    You can use a t-90 bearing retainer and make a spacer for behind it to take up the extra space.
     
    BobS, Jun 3, 2005
    #4
New Posts