Discussion in 'Flat Fender Tech' started by jackdog, Jul 25, 2022.
What's a good way to paint these? Also does any place offer the decals anymore?
PAINT STENCIL *FOR WILLYS JEEP * CJ2A CJ3A CJ3B CJ5 M38 GPW MB HOOD TAILGATE | eBay
Saw them, didn't want to pay $40 for four. Says you can only use them once.
Might do a search on this. There was a pretty extensive thread on this a while back with some good ideas.
Likely the factory used a roller. As above, search for previous discussion.
Found the thread, guess I'll try the roller method.
Best way I found to do letters is get a striping brush and use testors model paint. Do the outline lay it on thick so you only need 1 coat and fill the center while its still wet then go to the next letter
I did mine by hand with a small brush.
I remember in the old thread someone suggested a paint roller with a paperclip as a handle and a cigarette filter as the roller!!
I'm thinking maybe a sponge-faced "grouting" trowel. Coat it with paint then press it flat to the emblem. Essentially "printing" it evenly.
Separate names with a comma.