T14 Transmission Synchro Tool

For you folks rebulding your own 3 speeds, I have found an old shop tool that might come in handy for you.The tool is a spreader type tool that is used between the main drive gear and 2nd gear, to keep the 2nd gear synchro ring from being spread/damaged/enlarged during installation of the front/rear trans bearings. The synchro rings are fairly fragile and this helps to keep them at original diameter during re-assembly.This would work for T14 T15 and is not needed for T86 or T90.
If you have a FSM, the offical terminology of this tool is:
Tool WO-334, thrust yoke tool (made by Miller tools)
It is pictured in the trans re-assembly section of any FSM.
I have attatched a pic of the tool as well.
Any member who needs it, PM and pay for the ride, typically $4 or less. You can use it/keep it until the next member wants it. Pass it on as needed.
Moderators, move if necc, couldn't think of better spot except intermediates maybe

 

Jim,

Sent you a PM. Thanks!

-Jason