1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T14 output gear shim

Discussion in 'Early CJ5 and CJ6 Tech' started by termin8ed, Jul 22, 2013.

  1. Jul 22, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    I have the jeep at work and I was going to put the OD on. When I grabbed the output gear for the trans that is in the transfer case, it pushed in a good 1/4". Can someone verify for me that there is supposed to be a shim that goes between the rear case bearing and the output gear? if I'm thinking right it is about a 1/4 thick? might be about 1/2" larger diameter than the output shaft?

    Hopeing I'm correct so I can run home on lunch and see if I still have it on my toolbox somewhere.:oops:
     
    termin8ed, Jul 22, 2013
    #1
  2. Jul 22, 2013
    OzFin

    OzFin Vintage Jeep Guy

    Michigan
    Joined:
    Jul 16, 2007
    Messages:
    949
    Brian,
    Here is a photo of my T-14.
    There is a spacer that goes between the bearing and the output gear. Is This what you are refering to ?
    Oz




    [​IMG]
     
    OzFin, Jul 22, 2013
    #2
  3. Jul 22, 2013
    termin8ed

    termin8ed I didn't do it Staff Member

    Mason, MI
    Joined:
    Dec 22, 2002
    Messages:
    4,422
    can't see it on work computer...
    I'll check on my phone but thats probably it. I have no spacer right now.

    ...found what I was looking for.8) luckily I stuck it in my toolbox at some point and not in some box that got tossed.

    Now to see what else can go wrong
     
    Last edited: Jul 22, 2013
    termin8ed, Jul 22, 2013
    #3
New Posts