[IMG] [IMG] Bought this Frankenstein jeep for 900 bucks yesterday. Never worked on jeeps before so forgive my naivety. Previous owner says it’s a...
Couple things for sale T86 transmission in good shape, ready to drive. $350 Dana 44 carrier and gearset in very good condition. 4.10 ratio....
I have a crate with parts from two T-14 transmissions. The parts includes two transmission cases, mainshafts, gears, synchros, and 1 top plate...
That's not OMIX. My T150 pops out of 1st gear on decel. I pulled the top cover and before pulling it fully off I tilted it up just enough to...
Sooo... finally getting close to solving all my "immediate" driving issues. This jeep was a mess when I bought it... but she is now freeway...
Hi Guys—‘72 CJ5, 304/3sp. I have another thread going about the transmission popping out of reverse. I also hear a lot of rough bearings as...
I recently rebuilt a 1970 CJ5 with a F134 and a T90. Dropped the transmission and put in a new clutch and shifter top with forks. The...
Hi Everyone—just picked up a decent shape ‘72 cj5 with a 304/3 speed. Original engine and transmission I believe. Going through several repairs...
I finally got around to testing the drivetrain on my '70 cj5 and for some reason only the t-case driveshaft/yoke spins. No power at all to the...
Hi There Can anyone tell me where I can get an Adapter plate to fit a T-98 or T-18 transmission on a CJ5, CJ6 or M38 bell housing ? The jeep...
Can I use Mobilgear 600 XP 200 oil in my transmission and transfer case? It is a 90 mineral oil. On the MSDS says:"Optimised resistance to rust...
Over Memorial Day weekend I finished up the installation of my rebuilt T90 trans and Dana 18 t-case for my 1964 CJ5 (F134 engine). My old man had...
I just bought a 1968 Jeepster Commando with a Dauntless V6 225ci - previous owner put a lot of lipstick on it so looks good externally and the...
After some consideration and research, I am thinking about putting a manual tranny in my 66' commando. Leaning towards a 5 speed with overdrive....
Thanks to those who replied to my last thread, I've got my eye on a TH400/Dana 20 combo at my local salvage yard. I'm not completely set on that...
I know Novak has some sort of special sealed input-shaft bearing for the T90 that supposedly doesn't leak like the felt seal but they don't sell...
Separate names with a comma.
