I did try to download the manual but all I got was the pics? whatever. just got done cleaning the carburetor and that didn't change anything. I...
beefy axle. does it drive ok? what do you want to do with it? if it were mine if go back to spring under but that's just me..
no not yet. the rebuild kit is an order part and I was trying to avoid totally tearing it down. mid throttle is the float right. so maby needle...
correct. found the other screw after removing carburetor. replaced the power valve and accelerator pump with no difference. any other ideas....
I ran the screw in and it still ran but like crap
there is an idle screw and one air screw that I can find. are those symptoms of blown power valve
I think I only have one mixture screw on the front
are these symptoms what you would expect from a blown power valve? I haven't done anything to the carburetor and it happened so suddenly
so my jeep has been running great. yesterday was beautiful here in ne iowa so off I went for a cruise. after putting over 100 mi in and about...
so I had the red wire from ignition on the wrong side of the resistor, glad I found it but don't think it was the problem. added the extra ground...
good info but its not telling me why there is no spark. in the diagram above it "highly recomends" adding an extra ground to the black wire from...
yes I did use the resistor and it got hot don't know if that's normal. the diagrams are the same. what do you mean by conducting? when should...
I had 12v at the coil positive and at the neg. that seems wrong.
I am using a diagram posted by LBGORS I can't seem to link it. on inspection it is the same as the above post. that is how it is now wired but...
I have a 74 with a 304 from a 77 I am getting rid of the prestolite ignition for the motorcraft. I am not doing the tfi upgrade. I ordered...
personaly i wouldnt skip steps. rust encap stuff just coveres up rust. rust convertor actually converts iron oxide into something else. once your...
update for future sesrchers. on closer inspection, im an idiot. spring eye is 7/8" and thats stock.
i have searched here and everywhere and got nothing. here is what i got. 2+inch lift springs of unknown make. they did have a somehow...
im with Chilly. my heater keeps me toasty in Iowa winter and i dont even have a tailgate.
just wondering ir anyone knows if they are different of just painted different?
Separate names with a comma.