Looking best place to purchase quality master trans t-90 rebuild kit Need where to buy info
Looking for easy ideas putting smb 305 in a cj2-a, Info needed on smallest distributor dia to use? Keeping everything stock accept disk front...
Need info on the smallist dia. Hei distributor to avoid fire wall clearance Model or brand??
Where to purchase best quality T-90 rebuild kit and also 11.5 input shaft? Thank u steve
Looking to buy 225 v6 complete with flywheel, pulleys , manifolds Condition?? Not seized Prefer running
Looking for a rebuilder on east cost Not pricey
What is best to use on a old frame To stop rust Por-15? Or zinc oxide? Or other options?? I have the body off now
I sure many have ask before. Can i remove lower king pin And blow out old grease/oil from fill Port? I see many use john deere corn head grease,...
will old scout axles fit ecj5 frt and rear?
i just replaced my steering gear and trying to remember steering wheel neutral position? spoke center up or down?
Putting in a new electronic distributor. My past set up was a 12volt coil with a resistor before the coil. I had a solenoid supply 12 volt at...
Will a mb/gpw body fit on a cj3a frame? will rear shock location be a problem? any other problems?
Is there anyway to convert the oil type air filter to a filter element cartridge? and retain oem look? I have seen people do this with early MB/gpw
Need to have my carb rebuilt I would do it my self but throttle plate shaft worn Any names where to send would help
Many yrs back i bought a one pc tie rod that ea end went to both wheels. Anyone know if they still sell them? Cant find any listings
I see fuel pump spacers are use on some f heads, im putting a new crown fuel pump on and wandering if a spacer/spacers are needed Thank u
Hooking up a factory spin on filter unit. Need info on location of the center filter line location? I think it goes in timing gear cover? Any...
i just bought new piston, no T slots , no notch, no front arrow on pistons can no find any direction arrows . i going to put them in , hope for...
Can someone please send a blow up picture of the front crank shaft Showing gear ,slinger, shim Location (setup) Thank u
looking for a excellent quality rebuild kit soure? I see alot of low cost ones and very concerned if they are not to standards. also sorce for the...
Separate names with a comma.