This looks like a pretty good one - a one owner! Somewhat near where I work under the right circumstances I might be willing to go check it out...
Hey guys I am posting for a friend. Seeking a YJ project. Rusty is fine but the less rust the better but if it's not running or has a lot of...
Check it out you rusty cab loving dudes https://www.facebook.com/marketplace/item/832711814812263/?mibextid=dXMIcH
Barney's been sitting for weeks in the garage. Time to move him back to the shed, but although there's a couple gallons in him, there's no fuel in...
OK so I already posted about rust repair i'd like to do, now I am thinking that it would be worthwhile a swell as fun and interesting to pull the...
Hey guys, Well Barney had a rough winter, even though he was just plowing my driveway and cruising locally..his "starting to rust" status...
Hi all, You may recall I did a semi-rebuild of my F-head recently, including HG, new rings, head milling etc... Someone on here said to be...
Hey guys, I started a thread about a week or two ago about the "4 Wheel Drive" stencil for the tailgate of my '58 CJ-5. Based on Michael Perry's...
My buddy has an AMC-era Wagoneer (1973 I think) that is pretty rusty, but has some really nice goodies on it and he does good mechanical work so...
Hi all, My Jeep 3 speed (T90?) tranny has started a new habit that i don't like. More often that not when I go into 3rd it makes that grindy...
I was out in the garage today trying to figure out which part of the spare tire mount install I should do first. Issues are, there are two pieces...
Hi all, Is there such a thing as "correct" hubcaps for a 58 CJ5? I see pix of later vintage CJs with those super-cool center caps that have...
Hey guys, Barney, my '58 CJ5 has what is, as far as I can tell from reading this site a lot, a classic "CJ Lean" IN his case it is to the...
Hi all, Well looks like I have secured the requisite hat channel and baffle, (pending from CJ5/442 THANKS!!) and I got some good shots of the...
Hi all, I am looking to replace the glovebox latch mechanism seen below. As you can see, mine broke apart from the inside, this is what is...
Hi all, As most of you know I've been learning as I go on a snow plow project compliments of the very good deal I got from forum member...
Hi guys, During my recon mission to investigate fill and drain plugs and a general orientation of what's what underneath this thing I found...
Hey Guys As a follow up to the GL4 GL5 discussion, someone pointed out that if you have limited slip differentials you should use a fluid with...
Hi guys, I tested out driving with my plow set-up today by jacking it up and hanging the chain on the cylinder high enough to keep the plow...
Hi all, Can anyone point me to previous threads regarding these issues? Or give me a quick breakdown? I need to drain and refill all...
Separate names with a comma.