Getting ready to wire wheel and paint the frame on my cj5 I've gone around the frame and run across a couple of damaged areas that might or might...
While pulling the engine off my '64 cj5 (ALL RIGHT! down to the frame!) I noticed the Prestone Generator on my F-head listed 10W as it's output...
If this isn't the correct place please move me mods. My '64 is getting a D30 with 1-1/8" thick rotors (which I picked up for a $Jackson :))....
I have a 1964 CJ5 that I'm currently refurbishing. It's an F-head and has a T-90. It also has a D25 with a 5.38 ratio. I've read around the board...
Do I need to mark the flywheel WRT the crank? Also I'm replacing a 9.25" clutch with an 8.5" Flywheel is drilled for both and that's the one I...
So.....I've got the T-90 out(piece 'o cake with a tranny jack :) ) now I'm looking at the clutch and T/O bearing. My T/O spring is MIA. I was...
You guys have been a great source of knowledge. I feel like I'm the kid that asks too many questions but I really don't want to get off on the...
I thought about posting this in off-topic first -- mods if it belongs there please move it. Will flat fenders fit an early cj5? I've never seen a...
My fine FSM hasn't arrived yet and I've run into a snag; I bet somebody here has dealt with this before. I was busy taking the back yoke off...
My Quality factory FSM is on its way but in the meantime I can't figure out how to get the pin that the levers rotate around out in order to drop...
Thanks for the welcome in the into thread. Now that the rain has stopped I was able to climb under my cj ('64,F134,T90) and look at the too...
Separate names with a comma.