clean filter on it, fuel and tank are pretty clean. runs fine climbing hills, engine lope/popping when idling down a hill or if i let the rpms...
i dont mind building my own stuff. but the plungers all look different, lines come out different sides. etc. what has everyone done? i read...
ill have to pull the plugs, its a 2g carb, rebuilt a year or so ago, the accelerator pump works fine. with the choke pulled out a bit the jeep...
So i have the jeep running awesome. fires up easily, idles perfectly, loads of power, etc. its an hei at about 6-7 deg adv. no air leaks that i...
So ive been researching, and now my hear hurts. i have a 67 with the jam jar on the frame. i swapped disc brakes in the front. the jeep stops but...
im interested in seeing that crossmember! i got everything bolted together. now im fabing the crossmember, plan is to bolt to stock local on d18...
Also. the clutch (i thiink it was the clutch) was on some kinda cable thing that was between some bar connecting the frame to the side of the...
holy crap. well i got the thing into the bellhousing, everything went in kinda smooth minus the whole 7000 lb lift to get it in there. even with...
is there any passages within the gears that oil would travel in these? worried about any of that gunk getting in and clogging something.
thats the exact same numbers on mine. it came with an adapter, looks homeade. but works. I measured and double measured everything from length to...
Well. i didnt expect it but i found a t98 with the adapter for the same bellhousing (looks home made or old ) with the longer input shaft, granny...
I have a t90 (j?) behind a dauntless, with an adavanced adapters- adapter attaching it to the bellhousing. and a small bore d18. i blew up the t90...
finally got a chance to get into the jeep yesterday and look around, it says t90a on the side of the case, t90c on the cover. also a tag on it...
you guys are awesome. so far i havent found the time to get the tranny out the jeep. ( in the middle of moving and the garage is PACKED ) Looking...
dammit i had this typed out and it didnt post. Novak says, "The T90C has a 16 tooth, helically cut input gear. The cluster gear has a 35 tooth...
So i blew up the input gear (from what i can see its the only one) on my t90 (or so the top shifter cover says). It seems there are about 7...
In my endless googleing, i found one or 2 mentions that the whole disc set up from the knuckle out, from a 77-78ish dana 30, will bolt to the dana...
Housing is bent . Looking at other options I found the whole brake set up from the 30 will bolt to the 27. Its the 1-1/4 rotor. Anyone know where...
So i found a narrow track dana 30 with disc brakes the other day. to swap into my 67 with the dauntless v6, and offset 44 rear. My 27 wont stop...
Hi Everyone. Im new to the site, not to jeeps. So i got a new jeep, a 67 cj5. This site has been pretty helpful so far. but the "tech" page is...
Separate names with a comma.