Sorry for the extreme delayed follow-up - took me a while to get back to CA.... Well, after verifying the balancer was correct (it was) and valve...
Holy smokes! Thanks for all the suggestions. The engine has been broke in a while ago, heating has always been a little high, and now need to...
Thanks for the suggestions. Crewcheif22, I wanted to avoid that, but I think its innevitable. And the suggstion about the even fire cam is one...
Good thought, and I wish that was it, but no. The engine is a '69 225 which had all the original equipment on it, knew the original owner.
All, Here's a quick sum up of what's going on. 225 built from block up- .030 over with an rv cam, 4 barrell, blah blah. Anyway the engine...
If you're gonna wheel it....cj5 parts are easier to find than flattie stuff. Plus a lot of later cj7 stuff is adaptable. Probably a few more...
Thanks all. I saw something like this on TJ once but never thought I'd be able to get mine up completely flush. You'll noitce the 1" poly spacer...
Hehe thanks! 3/16" plate, didn't want to skimp. The tunnel on the later cj5 tubs is much larger and humps up higher. So I hiked the engine and...
Heres' a pic of my skid plates. Putting the '79 tub on my early frame, allowed me to suck the auto trans and tcase way up. What do ya think? Ty
Not sure if this is the right place to post...but the following is an awesome build up I came accross on Craigslist. Note the turbo and injection...
No, not ss. The only area I am a little conscerned with, is over the rear axle. The guy who ran the tube, could've sucked it up higher in more...
Just to clarify the photo of the driver's side muffler - yes those are fuel lines behind it YIKES. They were put on to moke jeep on and off...
Here's a few pics of my inboard exhaust - tight but doable...has not been "subscriber proven" yet Ty
I am running headers with saginaw steering. Used AA headers for a buick 231v6 converson for toyota. They dump inside the frame rails. Rear...
Steve, The exhaust changed dramatically as far as routing, and I did swap out the standard 2 1/2" flowmasters to 2 1/2" huff muffler...
Thanks, I'll check the vacuum. The timing was dead nuts. It's the same HEI setup I used (unaltered) with the manual. But, I will check it...
Yep it all makes since. Thanks Patrick and Jon My .030 over, cammed, 4barrelled, headered, v6 is kinda lame now----I'll give a valiant chance...
Hey Jon, TH350 is fresh with a transgo kit. I'm thinking that the good "snap" I used to feel must have been from that flywheel. Hopefully...
Hey all, FINALLY got back to the CJ5 swap. All finished (other than minor bugs) but notice that the jeep has considerably less power. Any...
Again very strange that you guys can't see it. I can go there no problem and view everything. set at 1600X1200 resolution? They sell both...
Separate names with a comma.