Alrighty, so I had some vibration issues (I thought from my driveline angle) that I "solved" a week or so ago. I have a 73 CJ with a ~3 in lift,...
Ok, so I just finished my transfercase overall. An idler gear, bearing, and arm were shot, along with some of the linkage. I also replaced the...
I finally found the time to pull my t-case out. The PO fabbed up a crossmember that supports both the t-case and my T-18. I was going to use a...
Went for a quick drive today and noticed some "new" vibration on acceleration that steadily got worse the closer I got to home. Crawled under and...
Can someone point me in the direction of an exploded parts diagram, specifically for the tailhousing on a 1973 Dana 20 transfer case? The ones...
So on the way to work this morning I threw my rear driveshaft. '73 CJ5, T-18 tranny, 2.5" of lift, and no shims on rear axle. I've read a bunch...
After a couple of weeks of putting off my wiring, I started on it today. Four hours later, I have all of the wires marked correctly and hooked...
My rear axle on my Jeep started to leak about three weeks ago from the pinion. Replaced the pinion seal, put everything back together, leaked...
I was looking at getting the BDS 2.5" lift for my '73 CJ5 and put it on this summer but had a couple of questions. I have a Dana 60 rear and a...
Separate names with a comma.