This statement, quoted above, leads me to think that the only possible answer is a screwed up differential, at least one, maybe both. If the...
Well not exactly. I have an AMC 360 that is getting put into a DJ5. I pulled the engine from the DJ 5 and found that it used a full...
My VIN was under the steering box.
Here is a picture of the rear spring showing the shackle and pin. [IMG]
Ok, I'll get some pictures. But explain the rears to me, if you would. On my DJ the rear mount of the rear spring is mounted to a shackle....
My 71 DJ has flat leaf springs in the rear and the front ones are bent up at the axle and look like a W. I'm thinking of putting a 2.5" lift...
Thanks for the replies and pictures! Jason, do you recall the brand of your fenders? I'm going to look into those.
I have a 1971 Jeep DJ. I'm finding out it is a bit of a bastard. It has what I think are standard CJ fenders, just with the turn signals on...
I don't know if your's can be rebuilt, but I recently had to replace a manual Saginaw box on my 1971 DJ. The cost to replace was minimal....
Re: New(old) Jeep. This one is a bit odd. It's a DJ-5B but with regular Left Hand S It's pretty cool. I think it depends on who you talk to...
So, in the quest to make myself a road-worthy, rolling, Jeep project I decided to redo the brakes on all four corners - and put in a new master...
Re: New(old) Jeep. This one is a bit odd. It's a DJ-5B but with regular Left Hand S I also picked up a tie-rod end for the pitman arm (that...
Re: New(old) Jeep. This one is a bit odd. It's a DJ-5B but with regular Left Hand S It's good to know there are some more out there. As...
Re: New(old) Jeep. This one is a bit odd. It's a DJ-5B but with regular Left Hand S [IMG] [IMG] [IMG] [IMG] The "custom welded steering...
Re: New(old) Jeep. This one is a bit odd. It's a DJ-5B but with regular Left Hand S Looks like I need to change my old signature line...
Hello. I joined this forum about 4 years ago when I had a 1963 Willys. That project was sold and I have since lived in several different...
I have a Buick 231, with buick bell housing, and a T90 tranny. I plan to use the Novak Adapters SBC/Buick adapter to mate the engine to the T90,...
Separate names with a comma.