Thank you for all the advice im most likely just going to use purchase the smittybuilt seats and i also realize that being my height no cj will be...
Well are there seats that are close to stock im not going to be going on road trips with it just cruising around town
Hi i have a 1955 cj5 that i have being restoring from the ground up and was wondering if anyone knows of good fitting seats that look stock. I'm...
ya I know that there's no roll bar stock; but thanks ill check out the smittybilt roll bars and see what I can find. Still if any one has plans or...
Hi I am in the process of restoring a 55 cj5 my dad wants me to install a roll bar. I was going to make it for my high school welding project and...
were the cj5 bumpers on the 55 and early models off set as in one side is longer than the other im speculating that this was on purpose to...
Ok thanks and also I did know that the cj s are all the same exsept the length and also the engine in my cj 5 is the f134 so ill measur and see
Ya sorry made a typo I did mean rapco so about how many coats of paint will I need for out side of the tub
Hey so i Was wondering If a radiator out of a cj6 will fit in a 55 cj 5 abd also are the grills the same
So I bought some Vietnam usmc forest green simi gloss gci paint from raptco for my 55 cj and I was wondering if I need a hardenr
Thanks for all the advice I will probably run standard gasoline and hope for the best
$400 well spent
So the my f134 started for the first time and it ran good thanks for all your advice
well I guess im fine then im pretty sure gas in California is ethanol based anyway
Thanks that makes things cheaper to also I know those vavels are tough because on my other engine you could see where the piston was broke from...
its an internal regulator but the forum thing says I can post attachments
so it sounds like I should put some in a few times a month then ?
hey so I was wondering if I should put lead additive in my f134 im certain that the valves are not designed for un leaded gas any recommendations.
ok I will and the whole engine is bolted to the frame so im good on that also I disconnected the drive shafts so I don't a have a run away frame...
ok thanks for all the help its really appreciated
Separate names with a comma.