Hey Nick, Sorry I haven't responded to your offer to help me with my powerlok. I really appreciate the offer, but I think I am going to leave...
thanks nickmil If I buy a rebuild kit will I be able to take one of the cone washers out of the clutch pack already in my locker and use that...
I have power locks in the front and rear of my CJ and they have served me well so far, but a jeep is never done. I rebuilt the 44 rear with an...
So you are totally right - the bearing race was retained by the brake backing plate and slid right out after I pulled the backing plate. I will...
I pulled the axles out of my dana 44 when I rebuilt my powerlock and realized the bearing setup is different on each side. The axle on the left...
That totally helps - Thanks Eric and everybody else who helped me along the way with this. The jeep community never ceases to amaze me. Thanks...
I purchased the aggressive kit for my dana 44 but the problem is I don't know the order of the clutches. It came with a convex disk (internally...
Thanks for the diagram. That helps a lot, but it isn't showing me where the other convex disk with gears and no tabs goes and which way it faces....
So I purchased my clutch kit for my power lok and now I'm tying to figure out the proper order for the clutches. I bought the aggressive kit and...
Thanks nickmil. My gears are 3.73 and since the clutch kits fit a series 3 or 4 power-lok carriers I should be good to go. I can't tell you...
I have power-loks in the front dana 30 and rear dana 44 of my jeep and I want to replace the clutches in both. I have seen some people refer to...
I need some help - OK a lot of help. I can't seem to find any information on rebuilding a powerlock. I did a search and there are a lot of...
Separate names with a comma.