You still looking for a Powr-Lok?
Thanks for all the replys. I don't think I am going to use these. I may sell them. Do you know what a fair price could be for each of them?...
I tried to get close ups of the numbers but it was very hard to see. I will try again. What are these considered, limited slips or full time...
Is there a way to find out what gear ratio they would work with?
I am going through some parts I have aquired over the past years and have 2 Lockers that I dont know exactly what they are. 1 is for a Dana 27...
Do you still have the Powr Lock available? Thanks, Kevin
Hey Desert Runner, look what I just found from my pics from 2002. This was the 4-wheel jamboree in Canfield Ohio. This was before I had a jeep...
Finally got it off. Thanks to Desert Runner for lending me his puller. Took alot of smacks and some heat but they finally came off. :) Thanks...
Unfortunately it is not running. This is an axle that im trying to take the gears from and put in the one that is currently on my jeep. Thats a...
I am near pittsburgh. Where you located?
are the studs and the drum one piece?
Here are the pictures [img] [img] [img]
I am trying to remove brake drums from a rear end D44. I belive it is out of a 1965. The brake drums and studs are attached. I have removed the...
Ok thanks. I recently found this one....
Just found a 1972 International-Truck Scout II. Would this contain a powerloc?
It is not a daily driver and if its on the road, its usually around town. Its a wheeler. From the sounds of it, i think im going to see how...
Picked up the axle and it happens to be a 4:88 gears. I am not sure what my rear end is (thinking 3:73) however i now know how to check it. I am...
Well i am going the d27 route for now. Cheaper! This guy from my club is selling me one for $10 so i figured if it doesnt work out then im only...
I am not sure what it is. I have been told it was a D27. Its a 64' CJ5 so..... I didnt realize I was getting hop in the front end. I dont...
Unfortunately I do not know the ratio. I am near Pittsburgh. In total, doing the work your self, how much do you think it all would cost to...
Separate names with a comma.