The horn button wire should go to the slip ring that contacts the brush. The brush connection goes to the horn. When the button is pressed It...
try isolating some components under load. Connect a hose to the fuel pump outlet at the fuel rail and dump it back to the tank. Direct hook up...
I used 1'' angle for floor bracing and a section of 1"x2" U channel for the body mounts. Locate the mount locations and weld in some captive nuts...
Just out of curosity I read somewhere that using a seat belt with a shoulder harness like in the newer cars have with a low back seat is a really...
I'm not sure if the 74 has a points and condenser system but if it does then I would suspect the condenser is breaking down when it gets warm. For...
Strider got it right only you don't have to run extra wires or cut anything if you have the factory wiring. Crawl under the dash with your light...
I went with the motocraft set up (larger cap and rotor ) that was scored form a pickup truck. I also got a thin film coil from a ford Tauris ....
I have an origonal Jeep 2" tach that bolts to the steering column but it is for a six cylender and connot be calibrated to read an eight. It is...
You could use silver solder available at any welding supply store. Another way would be to buy a brass nipple with a threaded end then thread the...
mine's blue
Separate names with a comma.