I'm an old hot rodder but relatively new to jeep rebuilds. Prior to finding this forum I bought a couple of cheap (thin metal, poor fitting) front...
Can anyone tell me what the single connector switch is on top of the T-18? I think the two pole switch (the one facing to the rear) is for the...
I've got the 232 out of the jeep and ready to clean and paint the engine bay & frame, plus new wiring, power steering gearbox and brake lines...
Any recommendations on a clutch kit for a 360? I'm not far from having my 360 ready to install in my '73 CJ5 and am about ready to buy the clutch...
I took Tim's advise and replaced rear main seal (rear main bearing looked pretty good...no wear patterns and no copper showing) and have a new oil...
Got an AMC 360 from a friend who said it only has 60k miles. Installing it in my '73 CJ5 (in place of a 232). Have pulled intake (installing an...
Picked up the 360 today and it has everything that was on the engine...accessories, brackets, ac pump, alternator, ps pump, air pump, etc....
Getting around to checking the differentials on my '73 CJ5 project and according to Chilton the front is a Dana 30 (it looks like a Dana 30) and...
It looks like I'm going to do it sooner than I planned. I've found a complete 360 Jeep engine that I'll be picking up in a week or so. I have a...
I've got a '73 CJ5 with a 232 and T18 four speed. Got tons of other work to do before I'm ready to think about an engine upgrade but was wondering...
Separate names with a comma.