two posible things I can think of 1- check the ground conection between the battery and frame, frame and engine block 2- brushes in the starter,...
. Apologies to 68 Swamper for hijacking the thread.... probably should start a new one for MC selection..... Al no apologies needed, I am...
I had 31 10.5 on a 15x8 rim with 3.5 back spathis is what it looks like with 33x12.5 tires on a 1cing .<br>just went to a 33x 12.5 on a...
I had 31 10.5 on a 15x8 rim with 3.5 back spathis is what it looks like with 33x12.5 tires on a 1cing . just went to a 33x 12.5 on a 10 inch rim...
X2 on steves post, when i put the dual mc from wilwood I only had to drill 2 new holes in the original mount, adjust the length of the push rod...
this is the master cyclinder , had to drill some ne mounting holes and , rework the push rod to the pedal,...
No issues with mine in two years. as far as seeing that kind of pressure I am lucky to see 50 lbs in the winter, Kaiser willys sells pre made...
mine are 1/8 npt / hose barb conections [IMG] IMG]http://i1085.photobucket.com/albums/j427/68swamper/oilfilter002.jpg[/IMG] [IMG] [IMG]
lots of money to get it to look like its clean, I found it in a field in 05 in Florida and talked the PO out of it for $1000 with the title , I...
Thank you everybody. being this was(is) my first convirson I was kind of confused about the thicker race. In my case with the 27 every thing...
I mocked up my disc breaks on the passenger side today with the original bearings and races -race LM 503110, and I think that I may needed the...
ok after reanding more of the comments on this thread I decided to do another dry fit of the rotars and calipers only I grinded the relief in the...
I just recieved most of my parts to do the conversion my self, I ordered a kit from Complete off Road, today I stripped one side down and did a...
picshttp://i1085.photobucket.com/albums/j427/68swamper/015-1.jpg
I have what you are looking for, But I am not able to post pics. I had no problem clearing the exhaust,but it was close about a 1/4 inch...
"What about the side to side clearence I mentioned above?" The fsm I have on the fhead shows .004 to .010 clearence checked with a feeler...
x 2 just went thru the same thing, started out with the brake light staying on, first long trip after mc replacement all for wheels locked up so...
I just put new glass in mine two weeks ago, tried three times before finaly getting it in, used lots of soap and plastic implaments (spelling) ....
olive drab # 1609, bought it from Restoration shop http://www.tcpglobal.com/restorationshop/rsp1609.aspx
old one was made of scrap rusted pipe and could not put it back on, it would have been a eye sore, but I did order 25 feet of 3" 40 last night , I...
Separate names with a comma.