Hi everyone, this site has been a great help in the past so I'm wondering if anyone can give me some ideas. My battery drains down quickly, I...
Anyone know what gauge metal the noram panels are that quadratec sells? Specifically the rear outer panels and inner fenders. Thanks
Hi, can anyone recommend a good air cleaner assembly for a 258 w/ a 2bbl carter on it. The local auto parts store has some small ones that have...
I am replacing the U-joints on my rear drive shaft(75 CJ5) and whoever replaced them before didn't use greasable joints. Can anyone tell me how...
Hi all, I have a question about my drive train. Should I have any play in my rear output yoke on the transfer case? My jeep just started making...
Hi all, does anyone have a pic of their jeep with 32 9.5 15's on it. I need to buy new tires and I don't really care for the width of the 33...
Hi all, I posted a couple of weeks ago about a noise coming from my intake. I thought at first it was the idle tubes, but I cleaned them...
Hi all, I have an issue with my cj. My engine will stumble on braking and also on downhill slopes(not as bad). I checked the idle tubes and they...
Hi all, does anyone have any pics of the muffler area of their cj5? I'm about to buy new stock exhaust parts from napa and there are a few...
Hi, I have a 258 with a carter bbd. Does anyone think that the carburetor could be dripping fuel onto the intake manifold and causing a slight...
Hi all, everyone has been very helpful in the past so I'd like to first begin by saying thanks. I have a 75 cj5 and I'm finally installing the...
Hi, I am having a problem with my fuel and temp gauges. The fuel sender is sending the correct resistance to the gauge but the gauge pegs full....
Hi, I have a carter 2 bbd on a 78 258. Does anyone know approximately how many turns out from lightly seated the mixture screws should be? My...
Does anyone have a picture of thier 75 transmission crossmember? My crossmember will not line up to the transmission, it's about 2" off(I tried...
I have a 75 cj5 w/ a 258, t-14, d-20, d-44 axle and my rear driveshaft angle is outrageous. I put a 2.5" lift on it and with the t-case lowered...
Hi, I have a jeep with some alignment problems. I checked the numbers and I have a T-14, Dana 20, Dana 44, and a 78' 258 engine. The body holes...
Hi, I have a jeep with some alignment problems. I check the numbers and I have a T-14, Dana 20, Dana 44, and a 78' 258 engine. The body holes...
Separate names with a comma.