Stock L-134 manifold has a baffle/butterfly plate in it. Originally I *think* there was some sort of mechanism on the outside of the manifold...
L134 with Saginaw box and pump adapted from a mid-80's XJ... After 8+ years of not running, I finally fired the old girl up tonight!! Smoothed...
Anyone know where to source a replacement gasket for the brake master cylinder cap? Mine is very brittle and now leaks... I'm retrofitting a...
I'm looking for feedback from anyone that may have done what I'm going to try... The stock grill hard mounts in (3) locations: Left, Right, and...
Has anyone ditched the mechanical fan in favor of an electric setup on the 134? My thought process is twofold: * Since I have added the...
Here are some pics of the re-rebuild of my beloved 2A. I started the initial rebuild back in ’02, but lost steam because we decided to build a...
Just starting to research the possiblity of adapting an SM420 to my beloved L-head, so I thought I'd start here... I realize anything is possible...
Tried this a while back and no one was able to produce any pictures... Still (ever so slowly) working on the power steering conversion on my '47...
Just fishing for some ideas on fabricated crossmembers to replace the stamped steel stocker in my flattie. Show me whatcha got :D
I basically need to replace EVERY part associated with the clutch and brake pedal linkage/assemblies... I have found a decent diagram for the...
Can the clutch cable (from the bellcrank to the t/o fork) be replaced without removing the tranny? I would assume so, but I haven't looked at it...
I've got the stock column removed and the Saginaw swap all mocked up. I would like to re-use the stock column by cutting it down to length and...
Can anyone post or link to some pictures of a power steering pump mounted on an L-134? I've got two pulleys on the crank, the front being a wider...
A few general questions about drum brake wheel cylinders: 1.) Do they all share a common "bolt pattern" to attach to the backing plate? 2.)...
I know the stock Carter WO doesn't like too much fuel pressure, but is there a spec for the Solex replacement? I would like to run a standard...
Please post or direct me to any/all pictures of a Saginaw conversion on an otherwise STOCK L-head flattie... I can't imagine how to route the...
I searched the forums to read up on the reverse steering swap, comparing it to the standard Sagi setup. I like the concept behind the reverse...
I know many of the purists among this crowd may cringe at this, but I'd like to find replacement seats for my '47 :shock: What I don't want to...
Years ago, I put a set of 1" Superlift springs under my '47. I built some shackles as well, replacing the stock 'C' units. The springs,...
When using the stock column and converting to Saginaw steering, my understanding is that you whack the steering column off a little beyond the...
Separate names with a comma.