I have that style hardtop also. The hinge bolts to the tub only not windshield frame. Have not installed top yet. Does anyone else have one of...
Stainless bolts will do. Thanks Dan
It's not green, it came from Wyoming. I think I will add drainage to prevent growing moss.
So there was no way for water to run off except slamming on the brakes and making a tidal wave ?
btt. hello out there can anyone help ?
In the jeep history research section the question titled " hardtop I.d. " would anyone have the top shown ? I just bought one but the rear corners...
O.T.C are good tools. They make stuff for mac tools without the price!
Belive it or not bought some from j.c. whitney. Latch type not push button look better on the vintage iron. Plus made in the U.S.A for 22 bucks each.
I would address the bearing issue first. "crunchy" is not good to describe a bearing !
Is anyone running the elite headers? If so how have they been?
crank,crank,crank and it should fire up.
It's available from napa p/n m3643. One inlet one outlet no return line fitting.
auto-matic wire strippers will speed things up also.
4 wheel drive hardware sells a molded vinyl floor covering by auto custom carpets for 1955-75 cj5. It's 200.00 bucks though.
What is the tube material ?
Your a brave man to go 60mph on the 210 or 10 fwy!!!!
Not a problem. Thanks for the help.
rob c. would it be possible to see a picture of the 12volt stencil.
What would be the correct finish for the headlight bucket? Zinc or galvanized plating ,painted or just raw pot metal?
To weld cast iron the manifold would have to be pre-heated before welding.:flag:
Separate names with a comma.