Let me see what I can pull together for pics Dan
I think it might be time to give up the willys. My truck is becoming unreliable so in order to finance an upgrade I figure i'll have to sell my...
Ok I think its pretty clear that you have to line up with the oil slinger. I had this same problem with my new Dist. sliding past the O ring....
How different are they? I think they may be the same, if I remember. Don't quote me on that.
Any idea on how many amps it can produce or the cold cranking amps? I've been running mine with a lawn mower battery. :D
What size battery does everyone use with there :v6: ? I think mine is about ready for replacement and I think I can fot a bit more battery in...
Update. I pulled the dist. and rotated the 1 post around facing a different direction. It started right up. Problem solved - but I'm still not...
Ok. I plugged the vacuum with a handy dandy phillips Screwdriver. I tripple checked TDC by bringing pulling the plug and making sure that the...
I have the vacuum off but I don't have it plugged. I didn't think that would really make a difference in trying to start it. I don't think it...
Thats what I keep thinking. I double checked TDC by taking off the tappet cover and making sure the valves were closed. I've been trying it...
Starting just counter-clockwise from the tab on the cap. Moving clockwise 165432. I think I've had them on and off 20 times in 3 days.
Do you mean the plug wires or the 3-wire harness between the dist. and the cap?
Does BF Goodrich make there All-Terrain KO tier to fit? This is a pretty popular tire for the reasons stated above. Good traction and rides well...
I am trying to complete my :v6: HEI Install. Its all in wired up and should run. I can crank on it and all it gives me is a couple chugs and a...
Tilt steering or not, your still real close to the steering wheel and its hard to get in and out. Consider moving the seat back a little. I...
Tank strap? isn't that what the seat is for? ;)
Problem solved. I had in/out mixed up :oops: . On my old pump there were different fittings facing different directions. I just re connected...
OK.. I just went and double checked all my work. It seems ok. Question though - which port is the intake and which is the out? on the new one...
Dissapointment. The arms are exactly the same. Same length, same bends. There was even a little oil mark where it his the cam - the same spot...
Hmmm.. Ok I'll run check that.
Separate names with a comma.