Sorry, Yes '75. I plan on having the mounts vertical and tight to inside of frame rail. Wish jeep was here could easily take measurements. Thanks...
Hey guys been too long. I'm back working on the jeep and building bumpers. I have looked but was hoping someone could either measure or just tell...
Dang, I had to ask:D Also have new tie rod ends u bolts spring bushings But I don't know how to check ball joints. No cracks in frame,...
Well, I got the shaft installed last night. I had to "persuade" the on header tube a bit to make the shaft clear. Sure hope this tightens up...
Not really what I was looking for, but thanks......
Dang, Nobody????
Hey guys, I am in need of an extension to my steering column. It's not stock, but the stock shaft works with it. What I am planning to do is...
I have done some reading and general concensus is that there will be spring wrap with XJ springs. I sure would like to lengthen the front but...
Just throwing it out there to see if any of you have done this to your Jeep to get more wheelbase and or better ride. I'm curious to know how...
I have had a few different carbs on my Jeep before I went EFI. Had the one barrel, ran like crap. Had a large 4 barrel, ran like crap. Went to...
I guess I was talking about my situation I guess:) I have EFI on mine already and would like to do the 4.0 head swap. If you are going V8,...
I would do the 4.0 head swap then instead of the 304. They are dogs. If you want V8 sound do the split header and dual glass packed exhaust....
I herculined mine. Reduced outside noise quite a bit. If I had to do it again, I think I would buy the Duplicolor stuff in a can and spray it...
If you are looking to spend money on that fresh engine, I would dump the carb and install a fuel injection setup. That alone woke my 100k engine...
I would have done the YJ spring conversion. I would have boxed the entire frame and fixed the small bad spot on the rear of frame. I would have...
I have a 258 with dual outlet header and dual exhaust with glasspacks. I have had many peoples jaws drop when I pop the hood and they see the I6....
I bought one off Ebay a couple of years ago. Worked good, EFI works great:)
Looks like 2.5 to me.
Someone on here has the long leafs as I asked about them before. I did a 4wd.com 2.5 inch lift and it rides a little better, but not great....
Separate names with a comma.