Thanks Jim, that clears it up for me and the fix as well. Thanks much!!
That's possible, but what has me stumped is that the inner grease seal is 2 7/8" OD instead of the correct 3" OD, suggesting a different drum....
OOPs! But That's how my fingers are labeled...:) :) :) If the race is fully set then I guess i'll just leave the clip off. Thanks!
Ok, here's some more info. The problem is with the right front. I just finished the left front. (It's nice to work 4-10 hour days so I can spend...
Re: Axle C-clip.... "what the hey?" Thanks for the response Tim. I forgot to mention that I did try the screwdriver routine but used a bolt...
Hi and thanks ahead of time. Front end is a D27. Ok here's the problem: After replacing my spindle and bushing I am not able to install the...
Thanks for the info Matt, I tried just freezing the Bushing but it still didn't seem to be enough, although I didn't try "wacking" it. I'll go put...
I know I've read this somewhere but not able to find it in the archive. But I assume I heat the spindle and cool the bushing to get them...
The following link has a nice electrical chart with Conservative curent values per wire size. Below the chart is a nice "calculator" that one...
DJ Frame to Cj conversion During my recent adventure to the Jeep Salvage Yard, a DJ frame caught my eye. It had been in the process of being...
Ok, so here's the scenario as I see it, when the right front wheel comes up into the wheel well: 1. After about 1.5 inches of travel the...
I agree, but what is confusing to me is that the distance from the bumpstop at the end of the arm is much less than the distance from the axle to...
Ok, I'm new to jeeps and still trying to figure how it all works. Yesterday I made my first trip to a jeep salvage yard near Sacramento, Wow was...
That's the one without the return line but has the bottom feed and drain. I just ordered it a couple of days ago for my jeep. I have an electric...
I recently had the same problem. It turned out to be a plug in the outlet of the tank. You can remove the tank pretty quickly and easily. Then...
John, Here's another idea for anti-wrap. Scroll to the bottom of the page. http://4wdandsportutility.com/tech/4wd0402_springs/
Here's a link to the Novak site that explains Lubrication and rebuilding the knuckles quite well. Hope it helps!...
Separate names with a comma.