Right now I have the dash mount off and the bolts from the frame. It looks like I may be able to slide it down enough to get a puller on it if I...
It's not the pitman arm thats off, only the steering wheel. The pitman arm is off by a spline or two. The hassle is that there is no room to get...
OK everbody, here's what I found out. Apparently the pitman arm nut must have come loose and the arm worked it's way loose on the shaft,...
I have the same issue with my early CJ5. Apparently a PO swapped in a 225 and I have the 4 cylinder steering box with no hole at the bottom for...
Pm'd you
homersdog, thanks for the info. The location of the numbers in the pictures on the first link are not where my numbers are. Mine are stamped in...
Is there a database or an online source?
I may have to try the tightsteer. Now after looking into it further, it seems that my vehicle may have started out as a 1969 CJ5 with the F-Head...
I got the sector shaft from either The Jeepsterman or Army Jeep Parts, pretty sure it was Jeepsterman. This was a couple years ago and they still...
Hi all, I have a early CJ5 with the 225 V6. I'm having a problem with excessive play in my steering. The steering box was rebuilt using a...
Can anyone tell me where I can find an complete air cleaner assembly for my 225 V6? Currently I have a oil bath and I want to switch to a paper...
Does anyone have a stock setup? I need one for my '62.
Shawn M, Those frames look just like the ones I have in my late model CJ5. Your passenger frame seems to have an extra "leg" towards the...
My 225 is spewing coolant from the overflow tube. New thermostat, rebuit engine. Started off slow then I noticed a big puddle underneath. Any...
Have you thought about buying a new wiring harness? The Jeepsterman in N.J. has them for around $265. It includes everything from the front to...
A couple of things: 1. Wouldn't the fuel gauge be grounded by the ground contact-to-case on the rear of the gauge? (based off the information...
Stan, I don't think it was too much voltage, because I had the voltmeter on it (showing about 12v) and I only got as far as turning the key to...
ok, I just took the face off the fuel gauge. as you look at it straight on, there is a metal band (fusable link?) on the left post that is...
Stan, I followed what you have on your site before the whole gauge cluster installation and that's where I'm stumped. I'm not sure on...
OK, I just looked at it again and did the same thing with grounding everythig. The gauge is out of the dash but grounded. The gauge worked with...
Separate names with a comma.