I need some help with my cooling system. I have a 71 CJ5 with V6 225. I have broken it down and am in the last stages of putting it back...
71 CJ5. I need to fab some brackets for my front seats. when I look at picts in previous post it appears that the front of the seat is higher...
After 2 years I am trying to start my engine for first time since I tore my Jeep apart. I have a 225. put in new fuel tank, lines and pump. now...
71 CJ5 V6 I have just reinstalled the parking brake on my dana 18 which the PO had removed. What are my best options on a pull handle? and how...
Can Someone please give me a drawing, photo or simple directions of the starter terminals and which would be the S terminal, R terminal and...
I have a 71 CJ5 V6 with 10"drum brakes. The PO of the jeep removed the wheel stops off the axle tube so my tires rub on the springs on hard left...
I have a 71 CJ5 and am looking for the center section of the front floor. The piece that has the gas pedal and is attached to the left and right...
I am currently putting my Jeep back together after a year and a half scattered in my garage. I did put in new clutch, fork and TO bearing. I am...
I have a 71 CJ5 Buick V6 T14 and a Dana18 with Warn OD. During my rebuild I have put in new clutch throwout bearing and fork. I did nothing to...
Does anyone have any advise or photos of what you did to replace the tub mounting brackets on your tub. Need to replace the 2 inner brackets that...
I have my new poly disc mounts. I know how to attach the 5 that attach the tub to frame mounts but what about the others. Do they just bolt to...
71 CJ5... I'm to the point where I am going to get the tub back on the frame. I am going to get a set of the poly disc mounts. The set comes...
It's time to remove and replace both front floor support hat channels and one rear on my 71CJ5. I have read in posts to drill out the spot welds....
When I tore down my Jeep I found the vent hose from my gas tank just tucked up under the tub. Now that I am putting it back together I need to...
I am getting ready to install new brake and fuel lines. My question is what do you guys do at the fittings? Should I use a teflon tape or lock...
Ok, my 71 CJ5 did not have an emergency brake when I purchased it. I just purchased a new brake set up from Herm to go onto my Dana 18 including...
I have a 71 CJ5 with 225 V6 the bell housing is the shorter style with a bolt on adapter for my T14 trans. as I'm putting this CJ back together...
Ok, so I know this has been talked about before. I am in need of a fuel pump eccentric for my 71 cj5 with 225. I have searched through past...
Ok, my project is a 71 CJ5. I now have engine out and on a stand (dauntless 225) and am ready to clean and paint. My question is now that its out...
I have a 71 CJ and am replacing bearings in bellcrank. The seals are very thin and fragile. Playing with the old ones they do not seem to go in...
Separate names with a comma.