A couple years ago at our Club's Jamboree a guy drove a stick through his steel YJ gas tank. They mixed a golf ball sized gob of Seal All with...
Common rot areas are the fender tops and the frame. The frame rots where mud lays in it, in the back by the coils and where the skid plate bolts...
I agree, surface area to the wind doesn't really change. Worst that can happen is you go from bad to worse. ;)
Wheel speed x diff ratio x trans ratio ?
That makes 2 of us, never heard of it before but makes sense.
You don't need to mount your shocks on top of the axle housing, you could gain a few inches mounting them on the back side of the axle tube.
The Astro drivers side manifold dumps closer to the middle, leaves about 8 +/- inches for a slave.
Cool Howard. My High School shop teacher warned me to never drive with NDT's in the rain. Apparently he's done 180's in his 3B.
I've got an '07 Grand. What really surprises me is the depth the windshield is set in, it builds up snow on the edges. Definitely engineered in a...
This is what I experienced when I put a new master on this year. Bend the hold down strap down in the middle so it puts more pressure on the...
Full size 90's GMC/chev vans have the pitman arm raised instead of lowered. Not sure if the tie rod end size or pitman arm size would work for...
Is the caliper on the wrong side? I see the bleeder is on the bottom.
Any reason you want in tank? I'm using a fuel pump mounted on the frame with a TBI 4.3. I carry a spare and could change it quickly on the trail.
[IMG]
Piratejack.net sells adjustable proportioning valves on ebay, they go for cheaper than their website. Mine should be here any day, and with...
With stiff springs like the stock ones it may not matter, but if your springs are flexy you may need more driveshaft slip spline.
Probably just make the carrier shorter than the bumper so the lights show?
I bought the Jeep with the axles hung, and the brakes hooked up. I replaced the brake hoses with braided for toyota and they worked, the last guy...
Neither of my dshafts are balanced, I've never noticed a problem, except right now my front shaft has a dent and twist, I can feel that. The...
Disconnect the cable from the transfer case and slide the inner out of the sleeve, if it's in 2 pieces you need a new one. Both ends of the inner...
Separate names with a comma.