Yeah mine is a Dana 44 axle. with no offset, but for some reason mine don't line up. Could someone take a photo of how close they should be? It...
Well I put it back together Sunday. I didn't get it right. I get some vibrations around 30 MPH. I've not driven my Jeep in almost 2 years it was...
It's the same shaft you have. I don't have one installed in the pitures. I take a pic of it tonight and upload it later. it's the XC model one.
Here are several pictures of my setup. I would think I would want to drop the drive train down to get it more inline with the rear diff. Correct...
I have wedges in mine also. BigJohn I would rather leave my T-18 in. What setup do you have? I also have a CV drive shaft too. Forgot to mention...
I have a 1974 CJ5. It's stock other than the 4" lift. I had someone install it for me a long time ago and they did it very wrong. My setup is a...
Never mind I finally found it in the service manual. Sorry!
I am trying to rotate my distributor 180 degrees. Ever time I try and insert it when I have to motor at TDC the rotor button wants to point at the...
There might be and idea. I guess I didn't think about it. I'll have to see if there are any kits for running LNG. I don't know a whole lot about...
I have the room for two decent size tanks where the back seat normally sits (No one in my family for my friends like to ride in my Jeep). So I...
With gas prices on the rise it's getting hard to drive the Jeep around. Is this a Partial propane conversion that would allow me to run propane...
Separate names with a comma.