almost need to use a winch to get my 36 inch swamper up there . i made it out of a trailer axle end for the swing [IMG]
here is some of my before after pictures all hand built no bolt on from the shackels to the hangers the axle perches , it has chevy half ton...
[IMG]
i just installed some 2.5 '' YJ lift springs and the jeep will list about 3 '' and when you get out it doesn't return back. i even switched the...
these are 11" drums i know the one with the big hole is but it looks like the hub goes on the outside is this the only option for tapered...
to many booster options is just best to fab in i already have drop pedals , is is best to look for the smallest im running a v8 , seen alot of...
wife's is going to kill me ive come up with 5 jeeps since december coudnt pass this one up i know its not stock but ive wanted one of these since...
picked up a cj3b hood no bracing at all any idea's what to use so i can put a hinge on it without looking to bad , only reason im trying to use...
r high hood and standard fenders the same
Can u use rear 11" backing plates and drums on the front Posted via Mobile Device
looking at a 42 ww2 that a guy wants to trade did they come with full floating rear axle or did somebody put it the jeep its a cj2a tub
Just got my f134 running , looks like alot of steam out of the exhaust ,doesnt smell like antifreeze is this normal , i let it run for about an hour
i have a 59 cj5 stock steering i thought it would be easier to switch columns then to loose my gut , im running a pto on the front so i dont know...
[IMG] built a new hub puller today bolt didn't hold up , do u have to wack on the hub or do i need to use a bigger bolt if anybody has any idea's...
[IMG][IMG] got the new 11" backing plates a little rusty but some spit and panther pi with clean them up also got the pto installed tonite had to...
i bought all new brakes for my 59 , haven't installed yet but i looked and i think i need new 9" drums what are some good doner's for 11" or...
i hav a 59 willys looking to put 10" drums can i use the stock master cylinder
Separate names with a comma.