My drivers side header on my cj3a just rusted out. I was thinking of going over to cast iron manifolds. Can any body suggest a drivers side...
Does any body have 1st hand experience using GL5 lub in there trans/tcas and then doing a tear down. I know its not recommended for trans with...
I already have the (cheep)? replacement electric wipers that sell for around $65 on my CJ3 but look like they couldn't handle more than the...
Dos any body know the diameter of the gm 4.3 large cap distributor. I am getting ready to fab my motor mounts and need to finalize engine...
I know I'm not really suppose to ask this twice but nobody seems to be going back to the steering conversion thread. I'm about to reinforce the...
I just got my Steering Linkage Kit from Herm. On the site it states there can be some interference but because of my aftermarket springs I have...
I'm looking at this header for my engine swap http://www.advanceadapters.com/products/pn-717019/ Has any body had any experience with it, also...
I was at the wreckers looking to make up an intermediate steering shaft for my covertion (S10 box and column) . I came across a JeepTJ shaft that...
I just pulled my t case for my engine swap. I removed the shifters and before I replace them I want to address the (side play)?. The shifters will...
I am looking for some basic roll over protection for my cj3a. I have not found any kits out there for bars or cages for the flat fenders but have...
I am looking for a doner truck for my "new" engine for my Cj3a. I aready have a old 60,s 307 in it so I thought a 4.3 would be a good replacement....
Separate names with a comma.