4 hours for a carb rebuild and tune-up sounds fair (evento cheap) to me if done properly. Is he adjusting the valves? checkingcompression? Using a...
I vote red or the same tan as your top if you want contrast.
Mud terrains yes all terrains are still on there web site http://www.bfgoodrichtires.com/tire-selector/size/LTHigh%20Flotation/33/9.50/15/tires...
OK I will pull the axle out of storage If its 30 spline I will be HAPPY HAPPY HAPPY if its 27 spline I will be putting it up for sale.
For this jeep I will be running tall skinny tires iether 235/85 r16 or 7.50-16 the only tire in a 15" rim ( that i know of) close to this any...
Reasons not to use a smaller or different height spare 1 steering - do much off a difference in size causes issues like the wheel not returning...
Well I have been searching for 16x7" rims that have the stock appearance. I contacted Stockton Wheel they could but my centers in a different...
IF there is enough left sticking out use a stud removal tool like this http://www.harborfreight.com/1-2-half-inch-drive-stud-extractor-94640.html...
After reading through the various post I am a little confused. I have a Dana 44 centered, flanged rear axle ( i took them out of a 68 Commando)....
with the small block chevy in you jeep I think the sm420 ot 465 would be your easiest swap I have seen the trannys with adaptors (used ofcourse)...
I don't know what you have done to your Jeep already or what your experiences with Jeeps are so here are the first things that pop in my mind, I...
They should be splined - I drive them in as far as I can with Large brass punch and 2 pound sledge. Then carefully tighten by hand the rest of...
Sorry typo - I set them with the upper king pin behind lower king pin in direrction of travel ( to clarify) Something else to consider-do you...
The inner oil seals he is referring to are behind the carrier bearing races. to change them you have to pull both axles and the differential....
The engine only has about 1,000 miles on it and I have all the 24 volt waterproof system for it. Thanks I am already indecisive enough the...
after rereading these posts several times. I came up with my brilliant new plan. to do things the opposite of how I usually do them. This will...
Well My plans are a full restoration of the body to Mill spec. But upgrade as much of the drive train as possible with out losing the stock look....
Thanks Ericm That is what I am looking for. What size tires , any lift on your jeep, Howfast on the flats in direct? This Jeep would hit 52...
Well the problem is my axle with 4.27 gears is centered not offset I will be rebuilding my rear ends anyway so a gear swap now is no big deal...
Well you asked for opinions If it were my Jeep I would keep the 225 but, My reasons may not be yours. How I drive my jeeps is short road trips (...
Separate names with a comma.