1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

cj3b ubolt specs

Discussion in 'Flat Fender Tech' started by Michaelo, Aug 2, 2010.

  1. Aug 2, 2010
    Michaelo

    Michaelo Member

    Neodesha, Kansas
    Joined:
    Sep 21, 2002
    Messages:
    90
    I am rebuilding a m416 trailer and hope to take it out camping this weekend. The only part I am missing is the ubolts. I was going to order some new ones but everyone needs measurements to make them. The m416 uses the same ubolts as the cj3b. I am on the road till wednsday and have no way to measure them and there are no local sources. I am leaving on this trip thursday so I need to have them shipped to me on wed or pick them up on the way home. Anyone got the measurements handy?
    Posted via Mobile Device
     
    Michaelo, Aug 2, 2010
    #1
  2. Aug 2, 2010
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    Does it use the same as the front or rear? The rear tapered axle Dana 44 housing is 2 1/2" outside diameter. I want to say the front axle tubes are 2 3/8" but can't remember for sure....
     
    nickmil, Aug 2, 2010
    #2
  3. Aug 2, 2010
    Michaelo

    Michaelo Member

    Neodesha, Kansas
    Joined:
    Sep 21, 2002
    Messages:
    90
    Front I beleive
    Posted via Mobile Device
     
    Michaelo, Aug 2, 2010
    #3
  4. Aug 3, 2010
    Vanguard

    Vanguard Take Off! Staff Member

    Vista, CA USA
    Joined:
    Aug 30, 2006
    Messages:
    2,259
    Vanguard, Aug 3, 2010
    #4
  5. Aug 3, 2010
    Vanguard

    Vanguard Take Off! Staff Member

    Vista, CA USA
    Joined:
    Aug 30, 2006
    Messages:
    2,259
    Vanguard, Aug 3, 2010
    #5
  6. Aug 3, 2010
    Michaelo

    Michaelo Member

    Neodesha, Kansas
    Joined:
    Sep 21, 2002
    Messages:
    90
    I tired to search with my blackberry but its hard with it left my laptop at home. Thanks everyone
    Posted via Mobile Device
     
    Michaelo, Aug 3, 2010
    #6
  7. Aug 3, 2010
    timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    23,596
    Those Crown numbers are the original Jeep PNs, as far as I can tell. The 8xxxxx are old Willys part numbers.
     
    timgr, Aug 3, 2010
    #7
  8. Aug 7, 2010
    sammy

    sammy Coca-Cola?

    Albuquerque, NM
    Joined:
    Jul 1, 2007
    Messages:
    1,577
    When I got new U Bolts for my trailer, they were same as the front axle in the Jeep IIRC. Uses the same hub assembly in any case.... I'll measure the radius (unless it's too late)
     
    sammy, Aug 7, 2010
    #8
New Posts