PTO setup for jeep

I have just purchased a old CJ2A to restore and have no use for the PTO set-up.. I could use the cash to buy parts for the restoration and have no idea what the PTO setup would be worth.. not good at posting pics but if someone is interested could send some pics.. thanks for any advice out there...can't seem to post pics so email me at neuby47@hotmail.com.. the winch is a Ramsey numbe953 or 958 can't tell which hard to read..

 

Is it a front and rear PTO or just a rear PTO or just a front PTO?

I've seen some go for around $200.

 

There is a PTO on ebay right now. It's a full set up.

 

I would be interested in the PTO from the rear of the transfer case. Could you check on the Model number-it should be cast on the body of the unit.
Thanks

 

We need way more info to pin down a value. Location and shipping costs can effect value as well. Does it have a winch, compressor, generator, or other things it drives? Brand? Condition? Front and rear output or only front or only rear? Does it have drive shafts? Gear reduction box mounted on rear? Condition of components? Need rebuild or useable as is?
These all have a bearing on value.

 

from what iv seen the pto unit itself can vary from about 80-500$ depending on what it is.

 

Jeep2003 pretty much nailed it - it all depends on what it is. I have a good bit of pictures and original brochure information on my web site for you to compare to.

I've got Spicers, a Ramsey and several Koenigs myself. I'm on a quest for a twin stick Koenig 50 or 58 or would settle for a Ramsey DP-1.

 

The winch is a ramsey # on winch is 953 or 958 not sure as hard to read, has a gear box on other end of pto shaft...has one shifting lever.. can't figure out the pics...

 

I had a tough time figuring the pics out too. But I could not see pictures in the posts either only the links. Turns out you have to turn the feature on in your account.

1. In the header above, click on "Your Account" a new page will open
2. In the new page, on the left column click on edit options under the "Setting & Options" topic.
3. Scholl down to the "Thread Display Options" check the show images box

As for the posting part, you need a hosting site and once they are loaded type the code:



Is this the rear gear box?

 

Hi, no its not that big, the shifing setup looks like the last one in the pics above on the right... will try to send some pics tonite, have to attend a luncheon and concert at grade shool in a few minutes with my honor guard for veterans day..... at least I am getting close to knowing what I have for a Pto setup... thanks

 

well somehow I did get pictures to post in album on this site, now if only I and anybody else can find them!!!

 

Go to "Your Account", Networking on left side then pics and albums...

 

You have a Ramsey PT-2 and a home grown shaft to a none standard Jeep box. Not sure if its a bearing or gear reduction box.

Your best bet is to clean it up good and put it on eBay. I'd expect you to get some were between $50 and $100 for it. If you remove the four screws in the top of the PTO the lever will slip right out allowing for a smaller box.

 

thanks alot, not what I had hoped but oh well at least its worth something... appreciate it... craig