replacing ignition lock and gear

I am needing to replacing my ignition lock cylinder and the gear that it slides onto. I know where to get the ignition lock, but I cannot find the plastic gear anyone know where to get it, and possibly other parts pertaining to it going down to the ignition switch.

thanks ,
mike

 

I assume you are looking for a '76+ GM type column parts?

If you mean the cam that connects to the rod which connects to the switch...try here:

http://thejeep.com/shop/HARD+PARTS/STEERING/Arms-Shafts-Wheels/NEW+REPRODUCTION%A0++STEERING+WHEELS+FOR+CJ+AND+AND+YJ+WRANGLER/4147364/4147364+UPPER+STEERING+COLUMN+RACK+AND+BEARING+KIT+USED+WITH+TILT+WHEEL+ONLY++1976-1986.html

Personally, I went to a salvage yard and pulled parts from any GM vehicle from the same era. I hope this helps.

 

steering colum / ignition lock parts

I went to go to replace my ignition cylinder lock this weekend, and behind it, what it slides into is this little plastic gear. well mine is broken and i cannot find where to get one. Anybody know of a place that sells these parts ?

 

Re: steering colum / ignition lock parts

Your OTHER post on the same subject had an answer that hopefully is helpful to you. A little info would be helpful for these fine folks to answer your question also. What year Jeep? Is it the stock column? If '75 and older what kind of column was used in the conversion? Is it a tilt column? Or not?

All these things can make a difference on you getting the right parts when it comes to steering columns.

 

Re: steering colum / ignition lock parts

oops !

sorry, I didnt think the other post went thru.

and your right, more info is helpful.

 

thanks, I called them up and they had the cam gear I was looking for.

mike