outer rear wheel bearing seal

just got some new ones and they are bigger than the originals, fit the outer portion of the brake hub instead of the tapered shaft. will they work or am i going to have to send them back?

 

the early seal sealed on the axle: Jeep P/N 935612

the later sealed on the inner hub surface: Jeep P/N 914802

both should be a seal/metal retainer 1 piece job

there were some paper gaskets sandwiched in between as well

 

thanks for the info and the move!!!

 

I think it's been discussed previously that the early seals were no longer made/available.

 

i'm sure it has, should a looked first thanks again for your time.

 

I have seen the older style on line, and can't remember where. I do remember that it was pricey, about 20 -25 bucks a pop.