1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

ramsey pt1-j question

Discussion in 'Early CJ5 and CJ6 Tech' started by oddfirejeeper, Mar 15, 2014.

  1. oddfirejeeper

    oddfirejeeper Active Member

    i have a 71 cj5 and wondering if a ramsey pt1-j will be a direct bolt on? the unit came off from a 55 cj5.
     
    oddfirejeeper, Mar 15, 2014
    #1
  2. jeep2003

    jeep2003 Well-Known Member

    I would say yes
     
    jeep2003, Mar 15, 2014
    #2
  3. Im a doughball

    Im a doughball Member

    Yep.
     
    Im a doughball, Mar 15, 2014
    #3
  4. 1957Willys

    1957Willys Member

    Yep I have one on my 57 CJ5.
     
    1957Willys, Mar 16, 2014
    #4
  5. uncamonkey

    uncamonkey Member

    Is this a pto that is supposed to bolt on where your overdrive is? If so, you're going to need the adapter housing to make it work with the OD.
     
    uncamonkey, Mar 16, 2014
    #5
  6. oddfirejeeper

    oddfirejeeper Active Member

    unca, yes i need to get the adapter down the road. and if my research is right the pt1-j is for the cj models and it doesn't matter what trans you have because it runs off the transfer case right?
     
    oddfirejeeper, Mar 16, 2014
    #6
  7. nickmil

    nickmil In mothballs.

    Correct. Remove the cover on the back of the transfer case and bolt on. If you have an overdrive currently you wl need an adapter and drive gear to bolt the two together the. Figure out shifter linkage.


    Sent from my iPhone
     
    nickmil, Mar 17, 2014
    #7
  8. oddfirejeeper

    oddfirejeeper Active Member

    thanks nick for the info. i thought that was all it was
     
    oddfirejeeper, Mar 17, 2014
    #8
  9. oddfirejeeper

    oddfirejeeper Active Member

    thanks to everyone who responded. wasn't really sure until i seen everyone had the same answer. thanks again
     
    oddfirejeeper, Mar 18, 2014
    #9