1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Shackles

Discussion in 'Flat Fender Tech' started by neptco19, Jan 8, 2006.

  1. neptco19

    neptco19 That guy....

    Did some quick searching for some replacement shackles for the 2a. And couldnt really find anything. Looking for some that add a little lift but no more than an inch. All the confer stuff I could find was for 55 and later...
     
    neptco19, Jan 8, 2006
    #1
  2. w3srl

    w3srl All-around swell dude Staff Member

    What's the diff between the flatties and the ECJs? I'm running cheapie lift shackles on my '2a and they bolted up just fine. Only gripe I had was that they're not greasable...
     
    w3srl, Jan 8, 2006
    #2
  3. neptco19

    neptco19 That guy....


    Are yours for an ECJ application?
     
    neptco19, Jan 8, 2006
    #3
  4. w3srl

    w3srl All-around swell dude Staff Member

    Yup. Got them from KRAGE IIRC. They're a no-nonsense setup with a square tube in between the plates. I added poly bushings, and greased them well when I installed them.

    [​IMG]
     
    w3srl, Jan 8, 2006
    #4
  5. neptco19

    neptco19 That guy....

    Thanks for the pic.. Those look simple enough to make. Guess I'll give that a shot :)

    btw Steve I think you have more than enough gas cans :D
     
    neptco19, Jan 8, 2006
    #5
  6. Gump

    Gump Old Timer

    Gump, Jan 17, 2006
    #6
  7. jpflat2a

    jpflat2a what's that noise?

    I used the Con- Ferr shackels on my flatty
    kit #'s J-2114, J-2115 J-2116 will work depending on how much lift
    you do have to install the early 5 rubber/steel or poly bushings in place of the threaded bushings
    some minor reaming of the frame hanger hole may be necc
    I installed non greaseable FYI
     
    jpflat2a, Jan 17, 2006
    #7
  8. jpflat2a

    jpflat2a what's that noise?

    Con-Ferr supplied info sheet/instructions
    you must purchase bushings seperately
     
    jpflat2a, Jan 17, 2006
    #8
  9. w3srl

    w3srl All-around swell dude Staff Member

    Yup, that's what I did. I had a heckuva time getting the the polyurethane replacement bushings into the spring eyes until I realized that it was much, much easier to pop the inner sleeves out and THEN slip the poly bushings into the springs. After that, the inner sleeves slid back into the bushings fairly easily, and it all bolted up just fine.
     
    w3srl, Jan 17, 2006
    #9
  10. michigan_pinstripes

    michigan_pinstripes I'm not lost, I'm wandering

    Many aftermarket companies no longer list flattie shackles and springs as the demand has dropped off. They focus only list 55 and above which do fit 2A's but they don't want to use up valuable print space or show it as a crossover application (for some reason)

    I like the Confers on mine but there are some nice "similar" versions that should do the job vs. making them at home.
     
    michigan_pinstripes, Jan 21, 2006
    #10