Well after much frustration, turned out my flamethrower coil was bad (thought they were supposed to be good for a long time?). I replaced it and...
Thanks. What about the number of turns on the mix screws? Can they be so different? I know 2-2.5 turns out is pretty common for 2G's. What are...
I just finished installing a rebuilt mc2150 onto my 225 with the mr. Gasket adapter #1937. It all came together fine but the jeep won't start. The...
This sounds like a great tip ^. Thanks.
Thanks for the ideas folks. One thing to note, I installed a pertronix kit in it last year. Not sure if that nullifies the cam lube idea?
Wow, ask and you shall receive..thanks!
How hard is it to put a 2100 on a stock intake? That may be a dumb question but I know nothing about the differences, if any, in 2bbl mounts.
If the issue is carb related, would replacing the 2g with a MC2100 be smart?
Any other symptoms or behavior typical of being 180* off? I guess going through and re-clocking would t hurt if it's not wrong?
I agree that the dirty fuel is a big issue. When the carb was off last, I could see and feel the sticky, tacky, varnished surface of the inside of...
Forgot to add that I've also briefly researched a 2g replacement. Most folks say keep it, others say the best replacement is a motor craft 2100 or...
I just asked a question regarding my poor running 67 too...I've rebuilt my 2g a few times this week! One thing I did just find was that I had one...
I am finally getting the heep up and running after lifting, adding sag steering, power brakes from an 89 xj, cj7 rear tank addition, and topping...
Separate names with a comma.