Yeah, I have a jeep guy a couple towns north. It'll be a pain getting it there and prob cost a a pretty penny, but at least I'm not in it too much...
I think pulling the tyranny is a bit beyond my skill and comfort levels. Don't have any fancy lifts or hydronic tranny supports? Never done it before.
Near Kingston. It wasn't truly a barn but rather a snake filled garage at the end of a driveway
Sorry for the delay in reply. Finally got a chance to work on the jeep the past few days. Its been a cold winter. I did manage to bend up new...
Makes sense. I will give it a try. Thank you
Nope, I made a point to make sure they were lined up properly. That was my first thought and what I thought the problem might be.
Thank you. I looked underneath while my son pushed the clutch pedal. The linkage works properly. However, call me crazy, but I don't seem to...
It doesn't matter what position the transfer case is in. I tried 2H, 4H, 4L. While running, I can put the transmission in all gears. Clutch does...
Hey everyone. I picked up a new toy/project a few weeks ago. 1961 CJ5, F-134 engine, T90 transmission, 4WD twin stick. I pulled it out of a barn...
Ok. I ran the tests Tim suggested and I got no spark. So I changed the solenoid, points, condenser and a potrion of the green wire running from...
I'm going to check power to the coil shortly. The info on the resister wire is very helpful. Thanks to all for the help. I'll keep you posted.
I replaced the ignition switch less than a year ago. Could it have gone that quickly? I will try the tests you suggested when I get a chance later...
I'll give it a whirl, but I don't think that is it as there is no spark coming from (or into, for all I know) the coil. Is there any way to see...
So I've been reading the archives over the last few days and cannot figure out what is going on with the Jeep. Its a 74 CJ5, 258 6 cyl, 3-speed,...
Separate names with a comma.