1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Rojo

  1. Rojo
    Post

    Rear Dana 44 axle shaft strength

    I broke a flanged 44 at the splines, It also took out my carrier. I was running 35's and got a wheel in a under cut. I went to superior shafts...
    Post by: Rojo, Sep 27, 2010 in forum: Early CJ5 and CJ6 Tech
  2. Rojo
    Post

    My pain in the wallet

    i totaly agree it just makes me sad. :(
    Post by: Rojo, Jul 29, 2010 in forum: Builds and Fabricators Forum
  3. Rojo
    Post

    My pain in the wallet

    I am in the process of taking my 71 cj5 from a cut up jeep to a full tube buggy. I finaly got around to the painful part of buying a dana 60 front...
    Post by: Rojo, Jul 29, 2010 in forum: Builds and Fabricators Forum
  4. Rojo
    Post

    My pain in the wallet

    [IMG][/url][/IMG]
    Post by: Rojo, Jul 29, 2010 in forum: Builds and Fabricators Forum
  5. Rojo
    Post

    My pain in the wallet

    I'm having trouble with the pic any words of wisdom?
    Post by: Rojo, Jul 29, 2010 in forum: Builds and Fabricators Forum
  6. Rojo
    Thread

    My pain in the wallet

    I am in the process of taking my 71 cj5 from a cut up jeep to a full tube buggy. I finaly got around to the painful part of buying a dana 60 front...
    Thread by: Rojo, Jul 29, 2010, 9 replies, in forum: Builds and Fabricators Forum
  7. Rojo
    Post

    link arc...........it works

    That is a very clean install. I might have to work that in on the tube chassis I am starting. Very nice. Scott
    Post by: Rojo, Jul 21, 2010 in forum: Builds and Fabricators Forum
  8. Rojo
    Post

    Axle Swap

    If your looking to get a better stance for the trail I say go for it. The dana 44 and the 10 bolt theres no difference in strength. I know you guy...
    Post by: Rojo, Jul 20, 2010 in forum: Early CJ5 and CJ6 Tech
  9. Rojo
    Post

    11" swap seal question

    Now that I saw the pic of the drum I was wrong thanks for the correction.
    Post by: Rojo, Jul 14, 2010 in forum: Early CJ5 and CJ6 Tech
  10. Rojo
    Post

    11" swap seal question

    The pumpkin looks like the offset 44 the drums look quite a bit different than mine do. Do you have a picture of the drum or with the drum off and...
    Post by: Rojo, Jul 14, 2010 in forum: Early CJ5 and CJ6 Tech
  11. Rojo
    Post

    Modern Radiator???

    GDI got me a nice replacement that bolted right up with no problem. It also ran 15 degrees cooler after.
    Post by: Rojo, Jul 14, 2010 in forum: Early CJ5 and CJ6 Tech
  12. Rojo
    Post

    11" swap seal question

    If I'm not mistaken and this is a offset flanged D44 it should have a seal at the end of the axle tube. There is no seal on the backing plate it...
    Post by: Rojo, Jul 14, 2010 in forum: Early CJ5 and CJ6 Tech
  13. Rojo
    Post

    Oil pressure

    Thanks for the help had a bad oil pump after me rebuild and seems to run ok with the new one thanks. Scott
    Post by: Rojo, Jul 13, 2010 in forum: Early CJ5 and CJ6 Tech
  14. Rojo
    Post

    what is this

    I seen one like this befor on early 2 1/2 ton But the back cover on this on looks different.
    Post by: Rojo, Jul 9, 2010 in forum: Early CJ5 and CJ6 Tech
New Posts