Anybody have thoughts on the Holley 600 cfm 4 bbl, and the Holley Sniper throttle body. I'm thinking ahead for the time when I rebuild my 304...
Well crap... I took a magnet, and checked the oil galley rear under intake, and found a small pc. of metal. So it appears a total take down, and...
you know I already dropped pan when I changed the freeze plugs a few years ago while it was sitting in my pole barn/garage, because I didn't run...
I didn't follow cam break in procedure.... because I didn't know better, now after only less than 1000 miles on a complete rebuild they look like...
from the lifter damage in the photo above, what would make them do this?
Here's what the lifters looked like. When I pulled valve covers off, and watched push rods were oiling, and when I depressed down on the lifters,...
I'm thinking that's what I'll do. cam, and lifter kit. The timing chain etc. should be good.
Probably what I'll do. It was rebuilt less than a 1000 miles ago, so dang.... change the hell outta the oil, and filters, and see if I can flush...
foolish me I didn't properly break in cam. I've had it in my pole barn, and only started it once in a while. The lifters probably got stuck from...
I just pulled the intake on my 304, and found both lifters in #1 hole were dished, and weak from long term storage. I had this 304 rebuilt about...
Separate names with a comma.