Just make sure you lubricate them. Otherwise the outside one will be running dry until the inside one leaks, and by that time the outside one will...
^This. I modified a wiper motor from a car to work in my old willys pickup, only to have the network of trapeze wires self destruct a week...
Rear axle is ready to finish weld, blast and paint. I managed to track down the original brake hose clips that I cut off this axle and reuse...
I grew up 12 miles from there. Used to cruise High St. every Saturday night in my 5! :beer:
That’s nice! I’ll bet his first reply will be some guy asking, “Can you tell me a little about it?” :bash:
Oh that’s so odd, I do like it.
4.3 should bolt right in, right? The (I’m assuming) T5 trans might not agree with that...
Yeah, it’s hard to find any that aren’t designed for desert racers with huge coilovers.
Compromises... In order to get away with ~18” belly clearance with only 32” tires and minimal lift, the t-case is tucked up much higher than...
A driveshaft’s u-joints don’t know the difference between sideways misalignment and up/down misalignment. Nobody seems to have an issue with...
If there is no lift, you can get away with the mis-alignment between the D20 and the offset rear until you find a proper axle. The T15/D20 setup...
That’s what I’ve read. I still might use the same stuff, but “Ford Gray” on the cage. It’s a really light gray; fade and chalk will probably go...
Nothing. Just cranked up the pressure a bit and let it flow thick, and I worked slowly. It gave me time to think. :)
Separate names with a comma.
