1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

ITLKSEZ's Recent Activity

  1. ITLKSEZ liked Howard Eisenhauer's post in the thread Which Is The Correct Or Better Rear Seal For The Dana 18 Transfer Case?.

    FWIW I packed bearing grease between mine.

    Nov 14, 2019 at 2:08 PM
  2. ITLKSEZ replied to the thread Which Is The Correct Or Better Rear Seal For The Dana 18 Transfer Case?.

    Just make sure you lubricate them. Otherwise the outside one will be running dry until the inside one leaks, and by that time the...

    Nov 14, 2019 at 1:27 PM
  3. ITLKSEZ replied to the thread Electric Windshield Wiper Conversion.

    ^This. I modified a wiper motor from a car to work in my old willys pickup, only to have the network of trapeze wires self destruct a...

    Nov 14, 2019 at 12:23 PM
  4. ITLKSEZ replied to the thread Varg In Jeep's Clothing.

    Rear axle is ready to finish weld, blast and paint. I managed to track down the original brake hose clips that I cut off this axle and...

    Nov 14, 2019 at 12:17 PM
  5. ITLKSEZ liked Keys5a's post in the thread Yup...i Want This....

    My oldest brother and his wife had a 4 door Eagle for years. That was the family car when they were raising their kids. 232 six with an...

    Nov 14, 2019 at 11:02 AM
  6. ITLKSEZ liked colojeepguy's post in the thread 1965 Willys Fc-150.

    I think we need to hear more about this :lol:

    Nov 14, 2019 at 8:27 AM
  7. ITLKSEZ replied to the thread 62 Cj5 With 231 And Fi.

    I grew up 12 miles from there. Used to cruise High St. every Saturday night in my 5! :beer:

    Nov 14, 2019 at 8:24 AM
  8. ITLKSEZ replied to the thread 71 Cj5.

    That’s nice! I’ll bet his first reply will be some guy asking, “Can you tell me a little about it?” :bash:

    Nov 14, 2019 at 8:04 AM
  9. ITLKSEZ liked fhoehle's post in the thread High Horsepower Front Axle Swap Ideas.

    I narrowed a Scout 44 for my CJ6 to regular narrow track width and run internal spline hubs on Chevy spindles and Ford Rotors. I have a...

    Nov 13, 2019 at 8:55 PM
  10. ITLKSEZ replied to the thread Yup...i Want This....

    Oh that’s so odd, I do like it.

    Nov 13, 2019 at 8:00 PM
New Posts