1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Howard Eisenhauer

  1. Howard Eisenhauer
    Post

    Sudden Failure Of Vacuum Pump?

    x2
    Post by: Howard Eisenhauer, Apr 24, 2024 at 4:52 PM in forum: Early CJ5 and CJ6 Tech
  2. Howard Eisenhauer
    Post

    Sudden Failure Of Vacuum Pump?

    Could be the diaphram, could be the check valves. Only way to know is to open it up.
    Post by: Howard Eisenhauer, Apr 24, 2024 at 2:05 PM in forum: Early CJ5 and CJ6 Tech
  3. Howard Eisenhauer
    Post

    67 Hubcaps, Ss Or Chrome Plated?

    Do a little polishing on the back side where it won't show & see what happens.
    Post by: Howard Eisenhauer, Apr 22, 2024 at 1:26 PM in forum: Early Jeep Restoration and Research
  4. Howard Eisenhauer
    Post

    Dana 300 Or Not??

    How's the output of the T98 configured? IIRC the M715 used a divorced xfer case & does not adapt well/easily to an attached case.
    Post by: Howard Eisenhauer, Apr 22, 2024 at 1:07 PM in forum: Builds and Fabricators Forum
  5. Howard Eisenhauer
    Post

    Re-sealing D18 Rear Output Shaft

    Actually if you split the felt into two you can get one of the halves in with the two FM seals. Not sure if it actually helps anything but what...
    Post by: Howard Eisenhauer, Apr 21, 2024 at 1:26 AM in forum: Early CJ5 and CJ6 Tech
  6. Howard Eisenhauer
    Post

    Re-sealing D18 Rear Output Shaft

    If you go the double seal route again (much recommended) these are the ones you want- [ATTACH] How's the surface of the output yoke? if it's at...
    Post by: Howard Eisenhauer, Apr 20, 2024 at 10:39 PM in forum: Early CJ5 and CJ6 Tech
New Posts